I am preparing to update my system to Oron NX 8GB with 2 IMX412 sensors. It must be 36.x due to some improvements by nvidia which should reduce latency.
The 0.18.0 release notes are unclear if this is supported.
In one place it says:
• NVIDIA L4T 36.2.0 (only NVIDIA Jetson Orin Nano + Orin Nano DevKit, experimental)
• this version has been tested with two identical IMX565, IMX567/8, IMX296, IMX226, IMX415 sensors
later, this indicates some support for the orin NX although my board is closer to the dev kit board.
• NVIDIA Jetson Orin NX
Auvidea JNX42
Auvidea_JNX42_OrinNX/tegra234-camera-vc-mipi-cam.dtsi
=> /hardware/nvidia/platform/t23x/p3768/kernel-dts/cvb
I have not yet tried to run quickstart.sh…
I do not see an active branch which indicates active work on your 0.19.0.
Should I pick up a different branch than master?
When is 0.19.0 expected to be released?
Will 0.19.0 support this combination?
Also, Do you plan to support DOL-HDR mode on IMX412 in the future? If so, when?
Thank you,
Michael Teitel
Director of Engineering
SB3D Technologies
(805) 766 3337
@.***
Peter,
I am preparing to update my system to Oron NX 8GB with 2 IMX412 sensors. It must be 36.x due to some improvements by nvidia which should reduce latency.
The 0.18.0 release notes are unclear if this is supported. In one place it says: • NVIDIA L4T 36.2.0 (only NVIDIA Jetson Orin Nano + Orin Nano DevKit, experimental) • this version has been tested with two identical IMX565, IMX567/8, IMX296, IMX226, IMX415 sensors later, this indicates some support for the orin NX although my board is closer to the dev kit board.
• NVIDIA Jetson Orin NX Auvidea JNX42 Auvidea_JNX42_OrinNX/tegra234-camera-vc-mipi-cam.dtsi => /hardware/nvidia/platform/t23x/p3768/kernel-dts/cvb I have not yet tried to run quickstart.sh… I do not see an active branch which indicates active work on your 0.19.0.
Should I pick up a different branch than master?
When is 0.19.0 expected to be released? Will 0.19.0 support this combination?
Also, Do you plan to support DOL-HDR mode on IMX412 in the future? If so, when?
Thank you, Michael Teitel Director of Engineering SB3D Technologies (805) 766 3337 @.***