Open GoogleCodeExporter opened 8 years ago
Greetings,
Great project!
One small issue I found was that when using an HMI, I could only read address 0
when I used 1 for register. Any other 30001 or 40001 and even 10001 were not
found and a zero was located at those addresses. I even used the test program
that creates random numbers in some of those registers and only saw a random
number at address 0. Hopefully, my Arduino Uno was not at fault. Other than
that, it worked flawlessly once I got the hardware issues out of the way.
Again,
Thanks and good luck.
RC
Original comment by rjcama...@gmail.com
on 9 May 2014 at 10:49
Original issue reported on code.google.com by
lii...@gmail.com
on 15 Dec 2013 at 3:18