Voron0.2r1

[nemgrea]

• we fixed the issue where 34mm z motors dont actually fit in the machine with the bottom panel installed, this involved

• increasing the height of the skirts/feet by 2mm

• we added a simple filament runout sensor to the rear right foot

• miniSB cowling part cooling ducts improved

• cam locks for the tophat are too easy to strip out, changed to a simple hex key design

• z endstop mount was beefed up a bit to prevent it from sagging

• an issue with the guidler being able to pivot in an undesired direction was addressed

• relevant open manual issues addressed

[crysxd]

I just checked the manual to install the runout sensor (looks amazing!) and noticed that on page 105 and 106 there is a screw shown instead of the switch that was added in page 104. Small detail, feel free to ignore :)

[nemgrea]

I just checked the manual to install the runout sensor (looks amazing!) and noticed that on page 105 and 106 there is a screw shown instead of the switch that was added in page 104. Small detail, feel free to ignore :)

sneaky little bugger that switch... should have it fixed in a moment here

[slashbeast]

Is there any chance the PDF with manual is corrupted? I have here commit 0740327f62441736f887b4a2ad35aa28765742b7 which gives me md5sum of c8a03f39a08806a2086160b3d56b3327 and nothing seems to be able to open this file (firefox, zathura, imagemagic).

[slashbeast]

@hartk1213 since you merged it, does the manual work for you?

[nhchiu]

@hartk1213 since you merged it, does the manual work for you?

Not working for me either.