Voron0.2r1 - [a]_MiniSB_Cowling_x1 HE Fan face only 2 layers (0.4)

[ningpj]

The front of the cowling around the HE fan appears to only be 2 layers thick (0.4)? Seems too thin and wonder if this is an oversight/mistake? In the previous release the front was 4 layers thick (0.8).

Layer 3 - New 0.2r1 on left, 0.2 on the right. Issue also with multi-part cowl version

[nemgrea]

the current STL's in the repo are 3 layers thick. looks like you downloaded the files before the PR was fully merged, this has been fixed

[ningpj]

no, i only downloaded the repo 12hrs ago from the default r1 branch. just grabbed a fresh copy and the files are showing as PR #291 which doesn't mention the fix and both cowls still only appear to only have 2 layers in the published STL's. Reexported from cad and its only 2 layers as well.

https://github.com/VoronDesign/Voron-0/blob/Voron0.2r1/STLs/Multibody_STLs/Cowling/MiniSB_Cowling_Multibody.stl https://github.com/VoronDesign/Voron-0/blob/Voron0.2r1/STLs/Toolheads/Mini_Stealthburner/%5Ba%5D_MiniSB_Cowling_x1.STL

[nemgrea]

Check your slicer settings the part thickness is 0.6

On Mon, Jun 12, 2023, 10:22 AM nigelpjames @.***> wrote:

no, i only downloaded the repo 12hrs ago from the default r1 branch. the files are showing as PR #291 https://github.com/VoronDesign/Voron-0/pull/291 which doesn't mention the fix and both cowls still appear to only have 2 layers

— Reply to this email directly, view it on GitHub https://github.com/VoronDesign/Voron-0/issues/296#issuecomment-1587561532, or unsubscribe https://github.com/notifications/unsubscribe-auth/AMM3G7NEPZ3WKA3NZUE7CO3XK4X3PANCNFSM6AAAAAAZDAZVLU . You are receiving this because you modified the open/close state.Message ID: @.***>

[ningpj]

Thanks, all good now...slightly thicker first layer so must have been on the margin since its still thinner than the 0.8 in 0.2

[scul86]

Check your slicer settings the part thickness is 0.6

I think there is a discrepancy between the CAD in the ~V0.2 Master Assembly RC2.zip~ V0.2R1 Master Assembly v62.step.zip and the [a]_MiniSB_Cowling_x1.STL in the repository.

I downloaded the stl, and pulled the cowl from the source .step file, and they are different.

• stl has a 0.4mm fan face
• step has a 0.6mm fan face.

I loaded both into SS, and split at 0.6mm. As you can see below, the stl version's fan face is lower. (Green highlight is pulled from the Master Assembly file)

[nemgrea]

V0.2 Master Assembly RC2.zip this is not the cad file that appears in the github....

[scul86]

Copied the wrong filename.

Reverified that I was using this file: V0.2R1 Master Assembly v62.step.zip