search

VoronDesign / Voron-0

Voron 0 CoreXY 3D Printer design
GNU General Public License v3.0
1.38k stars 387 forks source link

Bad screw length official support of no drop nut ? #356

Open Carlsans opened 3 months ago

Carlsans commented 3 months ago

On the Z motor mount, the lower diagram, I really needed M3x10, not M3x8. Since they are hard to install, it would be good to have it right from the start.

Carlsans commented 3 months ago

I realized that was one one the nuts I did not use a no drop nut because I did not have printed any at the time. The manual say that no drop nut are not supported by voron but yet they are expected. The solution would be either to use the correct length for user who don't use no drop nut or to officially include the use of no drop nut in the manual. The second solution would be very nice since it would allow the user to select the correct no drop nut size in advance. I had to heat gun the idler no drop nut because they were to long. Thanks for your good work :)

Carlsans commented 3 months ago

Had another issue with bare preloaded nuts. Had to add 2mm to nut length.