Adjustment suggestions for the manual

[Metti93]

Hello all First of all I would like to say that I, a CAD designer, am very enthusiastic about this great printer. The parts, as well as the manuals and the community are of high quality and unparalleled. That's why I want to use my skills as a quality manager and responsible for company standards in my company to make this great project even better. Starting with the manual! When I assembled my V0, I felt a bit lost in certain parts of the manual.

General hint:

• That Loctite might react with ABS+ and might not be beneficial in certain places. A note on this might not be so bad, for noobs like me.
• I would make the text bubbles and their text larger. I'm not the youngest anymore, and would have liked more readable texts. Also, I'm not a fan of white text on an orange background.
• I would introduce a bubble/color for optional hints. Be it additional M3 nuts for future extensions etc..

Page 6-7

• I would number the profiles. Because I made the mistake of installing the wrong profile right at the beginning, which is what should be needed with the frame. Of course, I then simply added two holes. But that could have been avoided.

Page 10-11

• "2x" is not in the same place, on both sides!!!!! 😉

Page 15

• Bottom left illustration. Write on, nevertheless, please, that one puts a M3 nut under there in each case. I had wondered what it is held by, or if on any other pages this screw is used for something else, because it sits there loosely.

Page 15-16

• As an optional note, I would add additional M3 nuts lined with foam tape (thanks Christoph Müller#3576 for the tip). Anyway, I would be happy if I had received such a tip early enough, and not only when I have assembled everything.

Page 20

• The title of the page is not aligned correctly.

Page 25

• A hint as to where the motor cable should look would be nice.

Page 27

• Backlash nut should be written on. Only at the end of the assembly, did I notice that this was missing. This was probably the worst thing missing from the manual.

Page 29

• Illustration at top left, "M3*6 BHCS + M3 Groove." Not that people use MakerBeam T-Nuts.

Page 30

• Foam tape would hold the nuts in place here, making it easier to mount the Z-motormount, but also the backpanel.

Page 34

• "M3*6 BHCS + M3 Nut."

Page 35-36

• M3 nuts, secured with foam tape, for future upgrades.

Page 37

• A measurement with the edge distance would be helpful, not that you tighten the rail in the completely wrong place already.
• Text "Use Rail Guides to Center Rail" is missing.

Page 74

• The M3 nuts on both sides of the rail should be listed, noticed they were missing on page 81. Had to take everything apart again.

Page 136-137

• The cable routing for the front fan, I would draw in better and route it through the notch for the left part fan.

For questions I am also available in Discord All in all, it was fun to assemble the Voron.

[mysfiring]

Didn't want to make a separate issue for a manual-related item: a callout on pg. 8 of the Pocketwatch manual - as a reminder to those using a non-spec motor - reminding the user that they should attach the 'pw_motor_spacer' at this point would be greatly appreciated! :D

[nemgrea]

manual is getting re-made for v0.1 these issues will be taken into consideration and implemented where applicable