search

VoronDesign / Voron-1

Voron 1 CoreXY 3D Printer design
GNU General Public License v3.0
192 stars 64 forks source link

PDF issues #42

Open sjtonic opened 3 years ago

sjtonic commented 3 years ago

Some Voron v1.8 manual PDF issues: p.32, misspelled Gantry in the title of the chapter, p.20, screws should be M5x30 BHCS

FHeilmann commented 3 years ago

@VoronDesign/documentation

axg20202 commented 3 years ago

The diagrams of the deck panel being mounted don't show the 20mm cutout for the bed wiring, leading some new builders to query where these are routed.

tobihille commented 3 years ago

Not sure if this is a valid point but i'll try anyway: I installed my dragon hotend backwards (because I was used V6 where orientation does not matter). On first heating up it melted my pl-08n probe because they both touched. A word of caution in the docs would prevent this probably so nobody does this stupid mistake again 😅