search

VoronDesign / Voron-2

Voron 2 CoreXY 3D Printer design
GNU General Public License v3.0
3.74k stars 992 forks source link

Fragile shaft #285

Closed jack9603301 closed 2 years ago

jack9603301 commented 2 years ago

Why can't we improve your shaft to increase its strength or reliability? I don't know if it often breaks due to printing problems. Can't we design our shafts as separate? Alternatively, a metal shaft is recommended.

During maintenance, it is often possible to open the door 180 degrees, which is easy to break in such a large angle and frequent operation.

raymondh2 commented 2 years ago

Which shaft? There are many shafts used in the build. If you are refering to the Afterburner hinge it is adequet as is and we have not heard reports of it breaking when ABS is used as the pin

jack9603301 commented 2 years ago

I mean the front door

Which shaft? There are many shafts used in the build. If you are refering to the Afterburner hinge it is adequet as is and we have not heard reports of it breaking when ABS is used as the pin

raymondh2 commented 2 years ago

This has not been an issue reported by anyone. I am closing this as a non issue

julianschill commented 2 years ago

There is also a Mod for hinges with M3 screws as shaft. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/mosher/m3_door_hinges

jack9603301 commented 2 years ago

There is also a Mod for hinges with M3 screwsas shaft. https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/mosher/m3_door_hinges

Yes, plastic shafts must not be used for door shafts, which will cause problems

I'm watching.

https://voronregistry.com/mods/270_clampinghinges_alexandert-moss