blower_housing_rear doesn't quite have enough clearance for the wires of the BOM (2.4) blower, leaving two options - wires are crushed against the housing, or remove the wires from their clips and risk them coming detached from their solder points. Both happened to me.
I made a very minor adjustment to the housing that alleviates the issue, which I thought would be good to illustrate
A fix for this was intended to be included in the May update. I'm not sure why it didn't make it in but I just included it along with several other corrections. Thanks for pointing it out.
blower_housing_rear doesn't quite have enough clearance for the wires of the BOM (2.4) blower, leaving two options - wires are crushed against the housing, or remove the wires from their clips and risk them coming detached from their solder points. Both happened to me.
I made a very minor adjustment to the housing that alleviates the issue, which I thought would be good to illustrate
marked up (master) stl showing location of required fix printed part with fix
Fix available in https://github.com/VoronDesign/Voron-Afterburner/pull/12