*Add Electrical Index.md file to add the Voron 2.4 Fysetc Spider V1.1 (tri_spiderv10_uart_wiring.md)
*reused three additional files:
a. Fysetc_Spider_ProbePort.md
b. Fysetc_Spider_RaspberryPi.md
c. Fysetc_Spider_Resources_v1.md
added initial Removal of Jumpers diagram
added initial preparation - Set Jumpers diagram for Fysetc Spider V1.1
updated description for Trident wiring diagram in Fysetc Spider V1.1
added wiring diagram for Trident - Fysetc Spider V1.1
*added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
MCU XYE with heat sinks
added SSR wiring diagram using Fysetc Spider V1.1
added URL to the Klipper Configuration from VoronDesign/Trident by Majarspeed GitHub Repo for Fysetc Spider V1.1
Updated Color Pin diagram for Fysetc Spider V1.1
added original SKR V1.3 pinout
*added URL to the original Fysetc Spider V1.1 Github Repo
*Add Trident FYSETC Spider V1.1 wiring diagram, This PR will not work properly without PR #238 . It contains a link to the information in PR #238
This PR also depends on the Majarspeed config file (https://github.com/VoronDesign/Voron-Trident/pull/31#issue-1060772897). I made sure the wiring diagram matches his config file for Trident Fysetc Spider V1.1 for both UART and SPI modes. Please add his config file to the Trident repo (please see Trident Repo PR #31). I will set the URL link for the Trident config file to the following (which is not a valid URL until Trident Repo PR #31 is add to the Trident Repo): https://github.com/VoronDesign/Voron-Trident/tree/main/Firmware/voron-trident-spider.cfg
*Add Electrical Index.md file to add the Voron 2.4 Fysetc Spider V1.1 (tri_spiderv10_uart_wiring.md)
*reused three additional files: a. Fysetc_Spider_ProbePort.md b. Fysetc_Spider_RaspberryPi.md c. Fysetc_Spider_Resources_v1.md
added initial Removal of Jumpers diagram added initial preparation - Set Jumpers diagram for Fysetc Spider V1.1 updated description for Trident wiring diagram in Fysetc Spider V1.1 added wiring diagram for Trident - Fysetc Spider V1.1 *added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
added SSR wiring diagram using Fysetc Spider V1.1 added URL to the Klipper Configuration from VoronDesign/Trident by Majarspeed GitHub Repo for Fysetc Spider V1.1 Updated Color Pin diagram for Fysetc Spider V1.1 added original SKR V1.3 pinout *added URL to the original Fysetc Spider V1.1 Github Repo