*Add Voron2 Fysetc Spider V2.2 in SPI mode, This PR will not work properly without PR #241 . It contains a link to the information in PR #241
this PR also assumes the PR #346 from VoronDesign/Voron-2 will be accepted, (https://github.com/VoronDesign/Voron-2/pull/346#issue-1206242459). The PR points the user to the Klipper config file and assumes that Voron2_Spider_Config.cfg file works with the Fysetc Spider V2.2 board.
*In Community/Electronics/ added the following:
GadgetAngel folder
images subfolder
updated Index.md file in Community/Electronics/ to add "Voron V2 - Fysetc Spider V2.2 Wiring for both SPI and UART modes" (v2_spiderv22_wiring.md)
v2_spiderv22_wiring.md is a parent to v2_spiderv22_spi_wiring.md
*reused three additional files:
a. Fysetc_Spider_ProbePort.md
b. Fysetc_Spider_RaspberryPi.md
c. Fysetc_Spider_Resources_v2.md
added initial Removal of Jumpers diagram
added initial preparation - Set Jumpers diagram for Fysetc Spider V2.2 in SPI mode
updated description for Voron 2.4 wiring diagram in Fysetc Spider V2.2 in SPI mode
added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
Added the following MCU with heat sinks in SPI mode
added URL to the Klipper Configuration from VoronDesign/Voron2 GitHub Repo for Fysetc Spider V2.2
informed use that the above config file needs to be changed from UART to SPI
added links to other resources
*Add Voron2 Fysetc Spider V2.2 in SPI mode, This PR will not work properly without PR #241 . It contains a link to the information in PR #241
*In Community/Electronics/ added the following:
updated Index.md file in Community/Electronics/ to add "Voron V2 - Fysetc Spider V2.2 Wiring for both SPI and UART modes" (v2_spiderv22_wiring.md) v2_spiderv22_wiring.md is a parent to v2_spiderv22_spi_wiring.md
*reused three additional files: a. Fysetc_Spider_ProbePort.md b. Fysetc_Spider_RaspberryPi.md c. Fysetc_Spider_Resources_v2.md
added initial Removal of Jumpers diagram added initial preparation - Set Jumpers diagram for Fysetc Spider V2.2 in SPI mode updated description for Voron 2.4 wiring diagram in Fysetc Spider V2.2 in SPI mode added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for: Added the following MCU with heat sinks in SPI mode added URL to the Klipper Configuration from VoronDesign/Voron2 GitHub Repo for Fysetc Spider V2.2 informed use that the above config file needs to be changed from UART to SPI added links to other resources