*Add Voron 2 Mellow FLYF407ZG in SPI mode, This PR will not work properly without PR #255 . It contains a link to the information in PR #255
*In Community/Electronics/ added the following:
GadgetAngel folder
images subfolder
updated Index.md file in Community/Electronics/ to add "Voron V2 - Mellow FLYF407ZG Wiring for both SPI and UART modes" (v2_flyf407zg_wiring.md)
v2_flyf407zg_wiring.md is a parent to v2_flyf407zg_spi_wiring.md
*reused three additional files:
a. flyf407zg_additional_resources.md
b. flyf407zg_RaspberryPi.md
c. flyf407zg_Resources.md
added initial Removal of Jumpers diagram
added initial preparation - Set Jumpers diagram for Mellow FLYF407ZG in SPI mode
added description for Voron 2.4 wiring diagram in Mellow FLYF407ZG in SPI mode
added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
Added the following MCU with heat sinks in SPI mode
added URL to the Klipper Configuration file by Antage (https://gist.githubusercontent.com/antage/1976d9df8e8a1126ebbe6f3935145394/raw/6bc4c53194be75a9889fba754ffa61fbb5c7cb89/printer.ini) for Mellow FLYF407ZG
informed user that the above config file by Antage needs to be changed from UART to SPI
added links to other resources
*Add Voron 2 Mellow FLYF407ZG in SPI mode, This PR will not work properly without PR #255 . It contains a link to the information in PR #255
*In Community/Electronics/ added the following:
updated Index.md file in Community/Electronics/ to add "Voron V2 - Mellow FLYF407ZG Wiring for both SPI and UART modes" (v2_flyf407zg_wiring.md) v2_flyf407zg_wiring.md is a parent to v2_flyf407zg_spi_wiring.md
*reused three additional files: a. flyf407zg_additional_resources.md b. flyf407zg_RaspberryPi.md c. flyf407zg_Resources.md
added initial Removal of Jumpers diagram added initial preparation - Set Jumpers diagram for Mellow FLYF407ZG in SPI mode added description for Voron 2.4 wiring diagram in Mellow FLYF407ZG in SPI mode added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for: Added the following MCU with heat sinks in SPI mode added URL to the Klipper Configuration file by Antage (https://gist.githubusercontent.com/antage/1976d9df8e8a1126ebbe6f3935145394/raw/6bc4c53194be75a9889fba754ffa61fbb5c7cb89/printer.ini) for Mellow FLYF407ZG informed user that the above config file by Antage needs to be changed from UART to SPI added links to other resources