*Add Voron 2 SKR 2 in SPI mode, This PR will not work properly without PR #270 . It contains a link to the information in PR #270
*In Community/Electronics/ added the following:
GadgetAngel folder
images subfolder
updated Index.md file to add "Voron V2 - BTT SKR 2 Wiring for both SPI and UART modes" (v2_skr2_wiring.md)
v2_skr2_wiring.md is a parent to v2_skr2_spi_wiring.md.
*reused two additional files:
a. skr2_RaspberryPi.md
b. skr2_Resources.md
added initial Removal of Jumpers diagram
added initial preparation - Set Jumpers diagram for SKR 2 in SPI mode
updated description for Voron 2 wiring diagram in SKR 2 in SPI mode
added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for:
*Added the following:
*Add Voron 2 SKR 2 in SPI mode, This PR will not work properly without PR #270 . It contains a link to the information in PR #270
*In Community/Electronics/ added the following:
GadgetAngel folder images subfolder
updated Index.md file to add "Voron V2 - BTT SKR 2 Wiring for both SPI and UART modes" (v2_skr2_wiring.md) v2_skr2_wiring.md is a parent to v2_skr2_spi_wiring.md.
*reused two additional files: a. skr2_RaspberryPi.md b. skr2_Resources.md
added initial Removal of Jumpers diagram added initial preparation - Set Jumpers diagram for SKR 2 in SPI mode updated description for Voron 2 wiring diagram in SKR 2 in SPI mode added the heatsink diagram to remind user to ensure that the heatsinks are installed on the stepper motor drivers for: *Added the following:
added URL to the Klipper Configuration from VoronDesign/VoronUsers TechnoPhreak's GitHub Repo (https://raw.githubusercontent.com/VoronDesign/VoronUsers/master/firmware_configurations/klipper/TechnoPhreak/BTT_SKR_v2/printer.cfg) for SKR 2 board added links to other resources