With the Pico plugged into the Pi via USB-C and the boot jumper installed, press the reset button.
Important: If your Klipper installation is located on a USB-SSD, it is likely that it is mounted as "sda"!
Run the following command before proceeding to the next step:
lsblk
Now check which sd_1 is specified with 128M.
Use this sd_1 in the following step!
Next we need to mount the SKR Pico to the Raspi to copy the file (klipper.uf2) over
https://github.com/VoronDesign/Voron-Documentation/blame/main/build/software/skrPico_klipper.md#L93
Important: If your Klipper installation is located on a USB-SSD, it is likely that it is mounted as "sda"! Run the following command before proceeding to the next step:
lsblk
Now check which sd_1 is specified with 128M. Use this sd_1 in the following step!