At the top, there's "If you did not run PID tuning, set your extruder to 245C and heated bed to 100C and let the printer heat up for at least 15 minutes."
But then, a little bit later, there's "Important: Klipper assumes that this process is being done cold. If being performed hot, do an additional TESTZ Z=-0.1 before accepting."
If you're supposed to run this tuning hot, shouldn't this just say "Important: Do an additional TESTZ Z=-0.1 before accepting", or something similar? It doesn't really matter what Klipper assumes; what I need to know is what I'm supposed to do, given the state the printer should be in.
At the top, there's "If you did not run PID tuning, set your extruder to 245C and heated bed to 100C and let the printer heat up for at least 15 minutes."
But then, a little bit later, there's "Important: Klipper assumes that this process is being done cold. If being performed hot, do an additional TESTZ Z=-0.1 before accepting."
If you're supposed to run this tuning hot, shouldn't this just say "Important: Do an additional TESTZ Z=-0.1 before accepting", or something similar? It doesn't really matter what Klipper assumes; what I need to know is what I'm supposed to do, given the state the printer should be in.