search

VoronDesign / Voron-Hardware

Cool Hardware designed by the Voron Design group
GNU General Public License v3.0
892 stars 353 forks source link

Shorter version still not short enough #162

Open djvj1 opened 2 years ago

djvj1 commented 2 years ago

Building a 350 now and the shorter stl still is about 2mm off from being centered with the misumi extrusion. I can't screw it into the t-nuts because of it z-endtop-issue .

bombela commented 2 years ago

Same problem. Formbot kit for 2.4r2.

Because I have added a layer of aluminum foil on the bottom panel, I must use the back cover (to prevent shorting out of the pins sticking out of the PCB). The M2 self tapping screws are recessed into it. I was able to install the endstop by bowing the bottom panel (covered with a layer of aluminum foil in the picture).

zendstop

Edit: I wasn't happy with the end result. I de-soldered the PCB and soldered the switch directly. I added a layer of kapton tape for electrical insulation.