Change the network of extruder to match 1pc (#203)

[qqqwqk]

203

before MCU's S1A is connected to stepper‘s S2A & MCU's S1B to stepper‘s S1A …… by this mistake

Change the network of extruder to match 1pc (#203) after

[timmit99]

this would be a @hartk1213 issues. Does it make sense to make this change?

[hartk1213]

this would be a @hartk1213 issues. Does it make sense to make this change?

no the older way is the way that was giving issues i dont think i updated the 1pc board but i might have just not updated the silkscreen the 2pc one is the correct one even if the silkscreen is incorrect , i could update the silkscreen and push a new version

[qqqwqk]

this would be a @hartk1213 issues. Does it make sense to make this change?

no the older way is the way that was giving issues i dont think i updated the 1pc board but i might have just not updated the silkscreen the 2pc one is the correct one even if the silkscreen is incorrect , i could update the silkscreen and push a new version

I produced both(1PC and 2PC) when I replacing it I had to swap the pins of extruded motor cable for it to work the better way is use same sch file to design and check to got best compatibility