search

VoronDesign / Voron-Hardware

Cool Hardware designed by the Voron Design group
GNU General Public License v3.0
874 stars 356 forks source link

v0 display stuck at DFU mode after upgrade #218

Closed stlfatboy closed 2 months ago

stlfatboy commented 8 months ago

sudo dfu-util -d ,0483:df11 -R -a 0 -s 0x8000000:leave -D out/klipper.bin

dfu-util 0.9

Copyright 2005-2009 Weston Schmidt, Harald Welte and OpenMoko Inc. Copyright 2010-2016 Tormod Volden and Stefan Schmidt This program is Free Software and has ABSOLUTELY NO WARRANTY Please report bugs to http://sourceforge.net/p/dfu-util/tickets/

dfu-util: Invalid DFU suffix signature dfu-util: A valid DFU suffix will be required in a future dfu-util release!!! Opening DFU capable USB device... ID 0483:df11 Run-time device DFU version 011a Claiming USB DFU Interface... Setting Alternate Setting #0 ... Determining device status: state = dfuERROR, status = 10 dfuERROR, clearing status Determining device status: state = dfuIDLE, status = 0 dfuIDLE, continuing DFU mode device DFU version 011a Device returned transfer size 2048 DfuSe interface name: "Internal Flash " Downloading to address = 0x08000000, size = 21156 Download [=========================] 100% 21156 bytes Download done. File downloaded successfully dfu-util: Error during download get_status

Failed to flash to 0483:df11: Error running dfu-util

If the device is already in bootloader mode it can be flashed with the following command: make flash FLASH_DEVICE=0483:df11 OR make flash FLASH_DEVICE=1209:beba

If attempting to flash via 3.3V serial, then use: make serialflash FLASH_DEVICE=0483:df11

make: *** [src/stm32/Makefile:111: flash] Error 255

... lsusb Bus 008 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 007 Device 049: ID 0483:df11 STMicroelectronics STM Device in DFU Mode ...

Follows flash guide, but ls /dev/serial/by-id/* not showing the device.

Found it boot into DFU mode again.

Using 0.12 klipper

PraetorianCZ commented 3 months ago

Did you have any luck solving this? Can you share you "make menuconfig" setup?

stlfatboy commented 2 months ago

Did you have any luck solving this? Can you share you "make menuconfig" setup?

it is a hardware failure, sovled by replacing the display module.