Closed jharmn closed 1 year ago
Can confirm that the new heater sensor pin is PC4 from my switchwire, so happy to see this config being submitted.
This config is bad!!!!!!! There are few wrong pins !!!
starting with:
############### [heater_fan extruder_fan] pin: PC15
should be PB15, PC15 is on E0_stop....
@luki343 you said "a few wrong pins", but only specified the PC15->PB15 (which has been corrected. Did you find any other incorrect mappings?
Pins remapped from v2->v3 Pin mappings tested on my SW