I'm on page 25 of the manual, attaching Tap_Upper_PCB_r8.stl and Tap_Front_r8.stl. I think the pockets for the M3x20 SHCS heads are slightly undersized. The screws got super hard to screw in towards the end, and started deforming the Front plastic. I stopped applying torque for fear of damaging the plastic parts.
In the pic above, the straight edge is resting on the head of the SHCS (near 105 mm on the ruler), after i screwed it in as far as i dared.
I've printed all the parts for my 2.4r2 and Tap on an enclosed Prusa Mk4, and this is the first issue with fit that i've run in to. So i think the printed parts match the STLs, and I'm suspicious of this particular STL.
I'm on page 25 of the manual, attaching
Tap_Upper_PCB_r8.stlandTap_Front_r8.stl. I think the pockets for the M3x20 SHCS heads are slightly undersized. The screws got super hard to screw in towards the end, and started deforming the Front plastic. I stopped applying torque for fear of damaging the plastic parts.I've printed all the parts for my 2.4r2 and Tap on an enclosed Prusa Mk4, and this is the first issue with fit that i've run in to. So i think the printed parts match the STLs, and I'm suspicious of this particular STL.