search

VoronDesign / Voron-Trident

Voron Trident CoreXY 3D Printer design
578 stars 173 forks source link

Manual: Jumper remove/install ordering suggestion #127

Open MallocArray opened 10 months ago

MallocArray commented 10 months ago

There is an inconsistency between the labels and order of removing jumpers from the board and installing the needed ones.

Page 203 covers removing jumpers in this order

  1. Driver
  2. Fan Voltage
  3. USB 5V
  4. LED Voltage
  5. Probe Voltage

  6. The next page mentions 4 of same jumpers, but in a different order

  7. Driver
  8. USB 5V
  9. Fan Voltage
  10. Probe Voltage
  11. Unlabeled 24v jumper

Compared to the previous page where the jumpers were removed, an improvement would be to keep the same step numbers where possible. This would mean possibly changing Page 203 the order of

Drivers Fan Voltage USB Voltage Probe Voltage LED Voltage Then in page 204, only the final step would need to deviate if reordered

Driver jumper location Fan jumper location USB jumper location Probe jumper location Wire jumper for 24VDC on far right