Closed bartlammers closed 2 years ago
@stvptrsn @KiloQubit as discussed, based the distances on the metric bed sizes. According to the drawings the hole positions are based on the single rear hole, so positioned the bed sketch there.
Updated z_tilt coordinates again, with values suggested by @stvptrsn on Discord
@stvptrsn could I draw your attention back to this?
Adjusted the z_tilt positions to match the positions of the bearing centers (the pivot points) to the CAD. This will differ slightly between metric and imperial beds, but close enough for both to let Klipper do its job.
The 300 and 350 rear positions were way off, which is the initial reason for this PR