search

VoronDesign / Voron-Trident

Voron Trident CoreXY 3D Printer design
582 stars 172 forks source link

Squaring instructions note to move the gantry to A and B drives to square. B drive has protruding Y endstop bracket. #43

Closed mobilemcclintic closed 2 years ago

mobilemcclintic commented 2 years ago

In the manual on page 118, we are instructed to move the gantry back to the A/B drives to square the gantry. The gantry hits the Y endstop block before hitting the A/B drives. This makes the travel on the right side shorter than the left and had me wondering how in the world I could rack the gantry but always have the left side not be the one stopping.

mobilemcclintic commented 2 years ago

2021-12-19 11_35_36-Autodesk Fusion 360 (Personal - Not for Commercial Use)

j-heffron commented 11 months ago

The change in the assembly manual noting to rack the gantry to the front idlers rather than the AB drive motor assemblies appears to have been reverted by #68. As far as I can tell, there has not been any change to the y endstop bumper part to warrant reverting the instructions.