search

VzBoT3D / VzBoT-Vz330

The VzBot 3D-printer
1.03k stars 163 forks source link

Firmware for the build #6

Closed mouamart closed 2 years ago

mouamart commented 2 years ago

A lots us not to familiar with firmware compiles. Is there going to be a firmware ready to use or a step by step on how to install the firmware for vzbot??..

simonvez commented 2 years ago

It is a bit hard to provide this. I can provide my klipper config, but its based on my printer. Not everyone runs the same board, drivers, electronics.. so it is very hard to provide all the information. I can however provide what I run if you wish

mouamart commented 2 years ago

It is a bit hard to provide this. I can provide my klipper config, but its based on my printer. Not everyone runs the same board, drivers, electronics.. so it is very hard to provide all the information. I can however provide what I run if you wish

Just provide firmware based on BOM parts and if you know some good YouTube videos and documentation as a reference that would be a bonus

karlspena commented 2 years ago

Please do

On Sat, Jan 8, 2022, 01:17 VzBoT @.***> wrote:

It is a bit hard to provide this. I can provide my klipper config, but its based on my printer. Not everyone runs the same board, drivers, electronics.. so it is very hard to provide all the information. I can however provide what I run if you wish

— Reply to this email directly, view it on GitHub https://github.com/VzBoT3D/VzBoT/issues/6#issuecomment-1007888753, or unsubscribe https://github.com/notifications/unsubscribe-auth/AJ7HC53BNJMX7ERYLE3SXODUU7CIHANCNFSM5KZFHE3A . You are receiving this because you are subscribed to this thread.Message ID: @.***>

thantik commented 2 years ago

A klipper config would certainly be a huge jump in progress when I get to that point. I'm still waiting on my parts from Mellow (CF tube and alum brackets), but I've got the Mellow Super 8 board, and basically the exact same configuration. Lots of boards actually route a lot of the same wires, so a klipper config will probably even match up with most other boards with the same processor - or at least is a good jumping-off point to modify to fit an existing board. Macros and such that you're using also give people sane parameters to aim for in order to replicate your work.

simonvez commented 2 years ago

Added https://github.com/VzBoT3D/VzBoT-Vz330/tree/master/Firmware