Clarify CPAP docs

[HumbleDeer]

CPAP / Umbilical Cord

Noted during stream: https://www.youtube.com/watch?v=9ZZNjZha22Q

Routing

1. How does the umbilical cord route?

   • Looks like it's along the cable guide
   • then on the back side of the back panel outside of the printer, in to the electronics box)
   • Does this use a printed part?
   • Looks like the top hat should have a cutout for the wiring loom to pass through; is the wiring loom protected?

2. How does the CPAP tube route?

   • Ties to the cable guide
   • Passes into the enclosure in front of the rear top extrusion
   • Goes into the round hole under the extrusion, at an angle
   • Does this use some printed part to protect the tube?

• Specifically for Mellow Vz330/Vz235: Perhaps the CPAP printed part at the print head could have a threaded section to thread the CPAP tube on to?

Toolhead wiring

• Does the umbilical cord get a protective sleeve, liek a braided sleeve?
• How does one attach the wires to the CPAP tube? Zip ties, or velcro ties? The CPAP tube is very fragile!