xerone9
commented
5 years ago Issue Resolved.
WOA Deployer dual boot tab keep showing that dual boot is enabled but the phone was directly booting to windows 10 arm instead of showing boot options.
The trick is to disable dual boot (via WOA Deployer) and then again enable it again
Hi,
I had install window 10 via this method "https://github.com/WOA-Project/WOA-Deployer-Lumia". but there is no dual boot option. The page said "Using this tool, you can enable Dual Boot in literally 2 clicks. Please, check this video to see a demo of this feature." Video demo just shows phone dual booting windows 10 arm and windows 10 phone but there is no tutorial for it. FAQ said use WOA deployer to enable dual boot. I had used WOA Deployer for the entire process of installing windows 10 arm on lumia 950 there are only 3 options "browse, deploy & Donate". The is no other option (I haven't seen) for enabling dual boot
Demo Video has 2 links in its description, Telegram link: Not working One drive link: Installation Guide of installing windows 10 manually
In Guide at the very end these methods are mentioned
Steps for Dual Boot (Windows 10 Phone and Windows 10 ARM)
Requirements
We should modify the BCD in order to show the Windows Loader entry. We removed it from the previous steps because it wasn't safe to select it until we discovered how to Dual Boot correctly.
To restore it:
Restore it with the command
Totally finish the OOBE process (first start setup)
Reboot to mass storage mode
Open DISKPART
Like the previous time you have to "select" your disk and partition with diskpart o LIST DISK o SELECT DISK x (where x should be the number of the disk which represents your phone) o LIST PARTITION o SELECT PARTITION y (where y should be the number of the “WOABOOT” partition we created for the Windows installation, which we assigned the "S:" drive letter)
Then set the type of the partition that identifies it as a "Microsoft basic data partition" with the following command (still inside DISKPART) o Set id=ebd0a0a2-b9e5-4433-87c0-68b6b72699c7
Reboot
Dual boot is now working
1st method (not working), the is no BCD Folder and BCD edit is an unkown command 2nd method (not working), Command prompt. Tried that too but not working (Note: there is not partition named "WOABOOT" just boot)