Assuming the interface board has the two 1x3 cxns, for the 1001 kit, it might be better to go with two of the single line sensors than the whole array. Make sure they have pins or sockets and the appropriate 3-wire cable. That both avoids soldering and keeps it all cleaner. (Soldering is not an issue, per se, but being able to remove/adjust wires would probably be a plus.)
Assuming the interface board has the two 1x3 cxns, for the 1001 kit, it might be better to go with two of the single line sensors than the whole array. Make sure they have pins or sockets and the appropriate 3-wire cable. That both avoids soldering and keeps it all cleaner. (Soldering is not an issue, per se, but being able to remove/adjust wires would probably be a plus.)