Debug Output

[pcasper90]

Hello, i have problems with the debug output. I configured baud rate 115200 and port7 is interface2.

[Wiz-IO]

seems like a Quectel problem... reflash module - IF problem again - ask your local Quectel support

[pcasper90]

local quectel support does not answer ..

[Wiz-IO]

https://www.quectel.com/support/contact.htm https://forums.quectel.com/

[pcasper90]

I flashed BC66NBR01A04V01 but still the same problem. Now i created a topic at quectel forum.

Support Contact formular and support@quectel.com don't answer me ...

[Wiz-IO]

BC66NBR01A10 recomended ... 04 ... is for old SDK

[pcasper90]

BC66NBR01A04V01 was the only version i found on the internet. but last night i got contact to quectel support. maybe i can get BC66NBR01A10 from quectel.

[nestorayuso]

ftp://staging.olimex.com/BC66/

[pcasper90]

Thank you now i flashed BC66NBR01A10 ;) But still the same issue for interface 2.

[Wiz-IO]

what is "interface 2" ? and port7 ??

[pcasper90]

[pcasper90]

interface 0 for at commands and firmware flashing works fine. or is it wrong, that i expect the debug outputs on interface2 ?

[Wiz-IO]

BC66 have only 2 UARTS

[pcasper90]

ok than i´m not sure how to understand the user guide. how can i see my debug ouput ?

[Wiz-IO]

define DEBUG_PORT UART_PORT0 or 1 and follow the module UART pins

USB interface is not supported in OpenCPU USB is only for Firmware updates, AT commands and Service debug/log

[Wiz-IO]

work?

[pcasper90]

not yet .. but just got new infos from quectel. i will let you know when i find my problem ..

[Wiz-IO]

BC66 OpenCPU UART-s ( in red )

[pcasper90]

I use the bc66-te-b

Debug Port (Interface 2) is COM10

But when use putty i can´t read it clear.

[Wiz-IO]

[pcasper90]

I want to use it without Arduino. So framework should be opencpu.

[pcasper90]

How can i see [APP] begin and [RIL] ready?

[Wiz-IO]

[pcasper90]

ok you use for both the same COM port. now i have a problem while uploading the program

[Wiz-IO]

install drivers