hello sir,
I am trying the example code of MC60 which is about SPI flash interface but I don't know how to communicate with q navigator using UART what input do I have to send to get communication started, as for now I was sending these inputs but its saying not found your command please check your command, please help me with this I am stuck here.
Thank you
If input "Ql_SPI_Init", that will init the SPI channel.
If input "Ql_SPI_Config", that will configure the SPI parameter.
If input "Ql_SPI_Write", that will write bytes to slave equipment through SPI interface.
If input "Ql_SPI_Read", that will read bytes from slave equipment through SPI interface.
If input "Ql_SPI_WriteRead", that will read and write bytes through SPI interface.
If input "Ql_SPI_Uninit", that will release the SPI pins.
hello sir, I am trying the example code of MC60 which is about SPI flash interface but I don't know how to communicate with q navigator using UART what input do I have to send to get communication started, as for now I was sending these inputs but its saying not found your command please check your command, please help me with this I am stuck here. Thank you