So over the last 2 days I decided to RGH 3 my xbox 360. I needed a PicoFlasher so I ordered one from Digikey last night and it arrived today. I hooked it up, stuck the u2f on the pico, and tried to read it in J-Runner. At first J-Runner couldnt find my console, so I decided to run it again. After that it said it was a 4GB Corona, which was not true, mines a Trinity. Anyways it tries to read the nand, errors out, then the light on my pico goes out, this was my big oh shit moment. So anyways I try re sticking pico flasher on there, but nothing happens when I hold down BOOTSEL and plug it in. I was using v3 of PicoFlasher, and as I said I've got a Trinity console. If you need to know, I did make 2 mistakes during the installation of the wires and everything. One was knocking off the capacitor next to PLL Bypass, but reddit said I should be fine. The other error was I accidentally ripped the pad off FT2V1, so I had to hook it up to DB2G3. Any guidance would be appreciated. I submitted an RMA to Digikey to see if I can get a new one, but any guidance in unbricking this one would be nice. Thanks!
So over the last 2 days I decided to RGH 3 my xbox 360. I needed a PicoFlasher so I ordered one from Digikey last night and it arrived today. I hooked it up, stuck the u2f on the pico, and tried to read it in J-Runner. At first J-Runner couldnt find my console, so I decided to run it again. After that it said it was a 4GB Corona, which was not true, mines a Trinity. Anyways it tries to read the nand, errors out, then the light on my pico goes out, this was my big oh shit moment. So anyways I try re sticking pico flasher on there, but nothing happens when I hold down BOOTSEL and plug it in. I was using v3 of PicoFlasher, and as I said I've got a Trinity console. If you need to know, I did make 2 mistakes during the installation of the wires and everything. One was knocking off the capacitor next to PLL Bypass, but reddit said I should be fine. The other error was I accidentally ripped the pad off FT2V1, so I had to hook it up to DB2G3. Any guidance would be appreciated. I submitted an RMA to Digikey to see if I can get a new one, but any guidance in unbricking this one would be nice. Thanks!