XFactHD
commented
1 day ago The placement behaviour of the Framed Slope Slab and its corner variants is unfortunately a bit confusing at the moment: to place them upside down you need to sneak while placing them. I would like to make this less annoying but I haven't found a solution yet that isn't painful in a different way.
Minecraft version
1.21
(Neo)Forge version
21.1.61
FramedBlocks version
10.1.4
Describe the bug
Hi, not sure if this is should actually be an issue opened as an enhancement and more of a suggestion, or if it should be opened as a bug, im very sorry if it should be the former.
As seen in the picture(sorry if its difficult to understand based on the image), the framed slope slab cannot be placed upside-down, or in other words, in an orientation where the flat side of the framed block is in contact with the block above it. As also seen in the picture, the elevated sloped slab, regular slope, and regular slab can all be placed in an upside down orientation, as can all of the slope panel variants, so this does not seem like intended behavior to me.
How to reproduce the bug
try to place a slope slab in a way where the flat(bottom) side would touch the block above it
Expected behavior
the slope slab would be in line with the elevated slope slab shown in the picture, with the sloped slabs "sloped" part gradually going into the block above it
Additional details
Using a framed wrench also does not make the sloped slab display the expected orientation
Crash log
No response