search

Xilinx / meta-xilinx-tools

Yocto Project layer enables AMD Xilinx tools related metadata for MicroBlaze, Zynq, ZynqMP and Versal devices.
MIT License
53 stars 51 forks source link

No valid device tree binary found - after added meta-xilix-tools layer. #24

Open jiin995 opened 4 years ago

jiin995 commented 4 years ago

Hello, we have a problem with this layer. We use poky zeus and after we configure bblayers.conf and local.conf as described below, when booting the target system (zybo-zynq7) on serial we see this error:

No valid device tree binary found - please append one to U-Boot binary, use u-boot-dtb.bin or define CONFIG_OF_EMBED. For sandbox, use -d initcall sequence 04063390 failed at call 04058b00 (err=-1) ### ERROR ### Please RESET the board ###

bblayers.conf

BBLAYERS ?= " \
  /home/se/yocto/test_from_0/poky-zues/meta \
  /home/se/yocto/test_from_0/poky-zues/meta-poky \
  /home/se/yocto/test_from_0/poky-zues/meta-yocto-bsp \
  /home/se/yocto/test_from_0/poky-zues/meta-openembedded/meta-python \
  /home/se/yocto/test_from_0/poky-zues/meta-openembedded/meta-oe\
  /home/se/yocto/test_from_0/poky-zues/meta-xilinx/meta-xilinx-bsp \
  /home/se/yocto/test_from_0/poky-zues/meta-xilinx/meta-xilinx-contrib \
  /home/se/yocto/test_from_0/poky-zues/meta-xilinx/meta-xilinx-standalone \
  /home/se/yocto/test_from_0/poky-zues/meta-xilinx-tools \
"

local.conf

#Top is default file except for MACHINE that is configured for build on zybo-zynq7

HDF_BASE = "file://"
HDF_PATH = "/home/se/yocto/test_from_0/poky-zues/zybo/gpio.xsa"
XSCT_STAGING_DIR="/home/se/yocto/poky-zeus/zynq/xsct"

XILINX_VER_MAIN="2020.1"
PREFERRED_PROVIDER_virtual/boot-bin="xilinx-bootbin"

IMAGE_INSTALL_append = " xilinx-bootbin" 
BIF_PARTITION_ATTR= "fsbl bitstream u-boot"
BIF_PARTITION_ATTR[fsbl]="bootloader"
BIF_PARTITION_IMAGE[fsbl]="${DEPLOY_DIR_IMAGE}/fsbl-${MACHINE}.elf"
BIF_PARTITION_DEPENDS[fsbl]="virtual/fsbl:do_deploy"
BIF_PARTITION_IMAGE[bitstream]="${DEPLOY_DIR_IMAGE}/download-${MACHINE}.bit"
BIF_PARTITION_IMAGE[u-boot]="${DEPLOY_DIR_IMAGE}/u-boot-${MACHINE}.elf"
BIF_PARTITION_DEPENDS[u-boot]="virtual/bootloader:do_deploy"

We tried to change xsa but the results is the same.

embed-me commented 3 years ago

I also used the zybo-zynq7 machine, 2020.1 and zeus as a starting point for a custom board development. Run into the same issue, however, adding CONFIG_OF_EMBED=y to the corresponding u-boot defconfig fixed it for me.