Closed X-Ryl669 closed 2 years ago
Yes. You can refer to the parameters of the relay
The trace width seems like they are 3.8mm on the bottom layer but 7.6mm is required to pass 10A on a 1oz PCB (unless there is a trace going under the relay themselves on the top layer too). Is the PCB copper layer made of 2oz ? Or is there a trace on the relay pin to the screw terminal block pin on the top layer too ?
Yes, it is not recommended to exceed the limit value.
It almost looks like there are traces for the relay on the top and bottom when examining my board. And 2 X 3.8 = 7.6 so it seems ok...
Thanks! I've received mine recently and indeed, there are traces on both side so it's ok.
I see you have mounted 10A relay. Are the screw terminal block and PCB trace matched for 10A ?