this is my first post here.
I have a simple question: I would like to power my LilyGo T-Display-S3 with a Li-On 3.7V 1000mAh battery. To do this I could take advantage of the JST connector on board and this is fine, in my opinion, if I want to directly connect the battery to the device.
I don't want this.
I would like to connect a more complex circuit to the device (with battery, buttons, etc.) and power the device via the female pins on the back.
Is it possible to power the device with a battery 3.7V directly on the rear pins?
If yes, what are these pins?
I have looked at the pinout of the board but there is no indication of such a situation.
Hi all,
this is my first post here. I have a simple question: I would like to power my LilyGo T-Display-S3 with a Li-On 3.7V 1000mAh battery. To do this I could take advantage of the JST connector on board and this is fine, in my opinion, if I want to directly connect the battery to the device. I don't want this. I would like to connect a more complex circuit to the device (with battery, buttons, etc.) and power the device via the female pins on the back. Is it possible to power the device with a battery 3.7V directly on the rear pins? If yes, what are these pins? I have looked at the pinout of the board but there is no indication of such a situation.
Thank you