search

Xinyuan-LilyGO / T-Display-S3

MIT License
731 stars 173 forks source link

BURN BOOTLOADER #191

Closed octopuss83 closed 2 months ago

octopuss83 commented 9 months ago

Hi ,

Sorry for my english I'm french . I have recently burn my esp32-S3 on a T Display board ( Hight voltage 20V accidently put on GPIO Input My ESP32-S3 is HS . I buy a new ESP32-S3 replace on T display bord and now I want to burn a new bootloader on this chip to restor my ESP32-S3 TDisplay BOARD is it possible ? with usb port ?

Thanks for response

teastainGit commented 9 months ago

"Sorry for my english I'm french . I have recently burn my esp32-S3 on a T Display board ( Hight voltage 20V accidently put on GPIO Input My ESP32-S3 is HS I buy a new ESP32-S3 replace on T display bord and now I want to burn a new bootloader on this chip to restor my ESP32-S3 TDisplay BOARD is it possible ? with usb port ? " Hi! I am fascinated that you were able to purchase an identical ESP32 S3R8! And solder it to your board? Good job! You do not need a new bootloader because the ESP32 S3 has the bootloader built-in, in ROM, so you should be able just continue uploading your sketches as before via the USB. -Terry

octopuss83 commented 9 months ago

OK thanks Terry , I prefer to repair rather than throw away but passionate about electronics I am equipped to repair CMS so at $4 why not. But from your response I just realized that I ordered the wrong version of the ESP32. I ordered the ESP32-S3 and not the ESP32-S3R8. I'm going to see how to adapt that to my card. if it is possible the PB being that I do not have a USB port.

20230925-173445-218

Thanks for your help

github-actions[bot] commented 3 months ago

This issue is stale because it has been open for 30 days with no activity.

github-actions[bot] commented 2 months ago

This issue was closed because it has been inactive for 14 days since being marked as stale.