Open PSLLSP opened 7 months ago
I think, I know the answer. My esptool
is too old. I updated esptool
to the newer version and it works:
$ pip3 install esptool
...
$ python3 -m esptool version
esptool.py v4.6.2
4.6.2
$ python3 -m esptool flash_id
esptool.py v4.6.2
Found 1 serial ports
Serial port /dev/ttyACM0
Connecting...
Detecting chip type... ESP32-S3
Chip is ESP32-S3 (revision v0.1)
Features: WiFi, BLE
Crystal is 40MHz
MAC: f4:12:fa:99:99:99
Uploading stub...
Running stub...
Stub running...
Manufacturer: c8
Device: 4017
Detected flash size: 8MB
Flash type set in eFuse: quad (4 data lines)
Hard resetting via RTS pin...
I am new to ESP32. I cannot use
esptool
with T-QT device. I am not sure if this is a bug in the T-QT device oresptool
. I use Linux Mint 20.3.Connection to the device timeouts. When I reset the device with button on the side, serial port
/dev/ttyACM0
disappears for a second andesptool
crashes:When I use the same procedure on some older devices with UART chip, there is no such issue because that UART is not disconnected during device reset; in most cases it is
/dev/ttyUSB0
and evenesptool
can reset device with RST signal...Any advice? Do I miss something? Can I use
esptool
utility with T-QT device?