KVM no longer working with v0.8.3

Ylianst / MeshCommander

MeshCommander is a Intel(R) Active Management Technology (Intel(R) AMT) remote management tool. It's feature rich and includes a built-in remote desktop viewer for Hardware-KVM, a Serial-over-LAN terminal, IDER-Redirection support and much more. MeshCommander is built on web technologies and runs on many plaforms. In addition to being available as a stand-alone tool, MeshCommander was built to be very space efficient to that it can be uploaded into Intel AMT flash space to have it served diretly from the Intel AMT web serve.

Apache License 2.0

369 stars 80 forks source link

KVM no longer working with v0.8.3 #11

Closed bthebaudeau closed 4 years ago

bthebaudeau commented 4 years ago

With my setup, KVM ("Remote Desktop" section) works fine with v0.8.2, but not with v0.8.3. After clicking "Connect", the state switches to "Setup..." for a couple of seconds, then to "Disconnected".

AMT host: Lenovo ThinkServer TS140, BIOS version: FBKTD9AUS, Intel ME v9.1.45 activated in Admin Control Mode (ACM), no OS, machine reset to BIOS. Client: Windows 10 Pro 1909, 64-bit, fully updated, RLE8.

bthebaudeau commented 4 years ago

MeshCommander was installed using the MSI installer.

Tell me if you need more information.

Ylianst commented 4 years ago

Thanks for the report. I just fixed it, you can re-download v0.8.3 now, it includes the fix. I will publish v0.8.4 in a few minutes.

Ylianst commented 4 years ago

Just published MeshCommander v0.8.4.

bthebaudeau commented 4 years ago

I confirm that this issue no longer exists in v0.8.4. Thanks.