Closed bakazm closed 5 years ago
ok, seems you have the newest hass , let me check when the requirement changed and what changed. My requirements seems outdated...
I take a look in this. I could not see the same on my venv system on newest hass. What components are enabled in your system or do you use discovery?
This is a completely clean install of the latest Raspberry Pi image using Hass 0.82.1. The only component I have is zha_new and discovery is enabled. The only add-ons that are installed are Configurator and Samba.
Can you please disable discovery and see if the error persists...
I disabled discovery (commented out the discovery line in the configuration.yaml) and rebooted. I got the same error.
please switch back to hassio 80.3 (see https://github.com/home-assistant/home-assistant/issues/17929) and check if it works
I used the SSH addon to roll back to 80.3. Rebooted and got the same errors.
I joined the beta channel and upgraded home assistant to 0.83.0b1. The zha_new component finally loaded correctly. I'll add some devices tomorrow to confirm that everything is working. Thanks!
I just confirmed that under the 0.83.0b1 build, zha_new loads correctly and is able to interface with my aqara motion sensors.
I'm having the same problem and am running Hassio on Raspberry Pi 3 B+. I've tried on both 0.84
and 0.85
.
0.86
was just released today, so I'll try again on that and report back.
Since I'm using Hassio, my command list is limited, so I can't upgrade or downgrade pycryptodome
or pip
.
did you tried mainstream zha ? the pycryptodome depdencency is in both version (my and mainstream) possible that hassio is broken again. if you have the same error on the mainstream zha, please open a bug inside homeassistant.
Thanks, I was able to get it working on 0.86.3
, but my SmartThings Multipurpose sensor (CentraLite 3321-S) was reporting "unknown" for its temperature state, and I was having trouble pairing some Xiaomi sensors and switches I recently got from AliExpress.
I think I'm going to try out Koen's Zigbee2mqtt solution and see how that works out. Thanks again for your help.
On a fresh install using the Raspberry Pi 3 image, I am getting the following error. I don't think I can run any pip3 commands because the rasp pi image's SSH is limited: