week of Aug. 15th 2018 - Githubissues

YoshinoriFujii / Weekly-task

0 stars 0 forks source link

week of Aug. 15th 2018 #1

Closed YoshinoriFujii closed 6 years ago

YoshinoriFujii commented 6 years ago

for 1.5 days for ITMX/ITMY:

[x] install LAN-HUB at IXV/IYV ~~lay pico-motor cables at IXV/IYV~~
[x] configure the picos ~~check the sensor/coil polarity for ITMX~~ ~~check F0-GAS status for ITMX~~ ~~release F0-GAS after FR-blade replacement.~~

for 0.5 days for ITMY:

[x] digital system check at IYV
[x] pick up primary coils and some jigs from IYV
[x] install one STM-driver at IYV ~~configure the STM-driver at IYV~~

for 1 day SR3: https://github.com/gw-vis/SR3_installation/issues/39

[ ] prepare the masses and place
[ ] measure resonant frequency vs. load
[ ] Tune IP resonant frquency

YoshinoriFujii commented 6 years ago

2018.8.15

install LAN-HUB at IXV/IYV configure the picos -two of LAN-HUBs are installed. The ip address was set into 10.68.150.18 for ITMX. but then the IP is not found now..

[x] this should be checked tomorrow.

[x] buy LAN cable 2m* #4

digital system check at IYV

[ ] check the BIO performance, when some circuits are off.

YoshinoriFujii commented 6 years ago

2018.8.16

configure the picos this should be checked tomorrow.

The IP address was set to xx.xx.xxx.0 instead xx.xx.xx.18. One problem: when I tried to change the IP, the final 2 digits were not changed from its web page. This resetting might be done with cable connection and with its application for windows.

[x] To be checked tomorrow.

YoshinoriFujii commented 6 years ago

check the sensor/coil polarity for ITMX

Only for the sensors has done. klog5819

check F0-GAS status for ITMX

F0 were not able to hold the section below the F1. klog5827

configure the picos

klog5832 http://klog.icrr.u-tokyo.ac.jp/osl/?r=5832