Closed Oleg23011977 closed 1 year ago
At the moment, when using Wan (Master), all traffic goes through it, ignoring the LTE module. If the Wan connection is interrupted, the file download is suspended, after a while it resumes via LTE, but when the wired connection is restored, the speed goes through the wire at a minimum. As if MPTCP is using LTE as (Master). if you do Speedtest, then I observe that the speed is high, and goes through Wan, after some time (3-7 minutes) the file may continue to load quickly
What is the version of OpenMTPCProuter used ? Can you take a screenshort of System->OpenMPTCProuter, Status tab ?
v0.59.2alpha-5.4 r0+16819-1b6e9b3f64
Wan не принимает участие в загрузке. Хотя он активен.
Later I will order another server and check. Today, under heavy load, I received an error.
You need to set SQM download and upload speed.
Pardon my ignorance. There is an article where it is described.
I tried to enter numbers.
But I can't find the right values. Therefore, I doubt that I am pointing this out in the right place.
And rented another server. increasing CPU=2cor 3.3 Mem 2g.
As long as I do not connect the Wan wire, the device works correctly and sums up the traffic of 2LTe modules.
But when I connect only Wan , I already start having problems.
Problem solved.
Wan very large Ping > 80 -120 Ms.
To check, I made another Wan channel, everything works as it should.
You should make SQM changes only using wizard if you don't know what to set in SQM menu.
How to use Wwan (Huawei B818-263) and 7455 modem together?
How to use Wwan and 7455 modem together?
Is it possible to make sure that traffic is always through Wan + LTe??
Current Behavior
Specifications