Open helixzz opened 7 months ago
FYI: This is not likely related to PON firmware nor the configuration. Seems it's more related to problems on the OLT side.
Added method to change MAC and LOID. (/doc/XG-99x_Config.md)
Normally, the OLT authenticates with the ONU MAC. If the MAC is blacklisted on the OLT side, the only way is to get a new MAC address. To accomplish this, contact the ISP or request an ONU replacement.
PON stick: FS XGS-ONU-25-20NI with rewrited 10G EPON firmware. This problem occurs after accidental broke and repair of the PON fiber.
The cold connector broke while I'm moving my rack and streched the fiber, which caused the receive signal strength is slightly below -30 dBm and it apparently unacceptable. The PPPoE connection lost at the same time. After rework of the fiber connector, the Rx signal recovered to acceptable level. However,
dmesg
shows the PON stick's registration state is flapping every 10 seconds. The PPPoE connection can't establish andpppd
stuck at error message "Timeout waiting for PADO packets" and "Unable to complete PPPoE Discovery".Tried to alter the MAC address of the PON stick to find out if we're blacklisted by the OLT. No luck.
And those lines just repeat forever...