It would be nice if there were an uploader only mode or a simple mode just for boards that have known settings like most Arduino boards and clones. Also this would be a setting that the programmer should remember ie. if I reopen the app it should open back up in simple mode.
Basically just a hex file selection and drop down for selecting the board type.
It would be nice if there were an uploader only mode or a simple mode just for boards that have known settings like most Arduino boards and clones. Also this would be a setting that the programmer should remember ie. if I reopen the app it should open back up in simple mode.
Basically just a hex file selection and drop down for selecting the board type.