I'm using a Creality Ender 3 v2 printer which has printed ducts.
The stock printer has pretty poor clearance angles due to the nozzle being quite close to the heat block.
I've been curious if using an extended nozzle or extension for the standard nozzle is an option.
My primary concern is that moving the nozzle further from the heat block will cause the filament to cool too much before extrusion.
Has anyone had experience with this? Good bad or otherwise. Keen to hear feedback.
A question for users, not an issue.
I'm using a Creality Ender 3 v2 printer which has printed ducts. The stock printer has pretty poor clearance angles due to the nozzle being quite close to the heat block.
I've been curious if using an extended nozzle or extension for the standard nozzle is an option.
My primary concern is that moving the nozzle further from the heat block will cause the filament to cool too much before extrusion.
Has anyone had experience with this? Good bad or otherwise. Keen to hear feedback.
Thanks