Open SargFowler opened 4 years ago
This version of checkm8-A5 does not work for me, but the synackuk version does. Perhaps there's some difference fixed in the synackuk version? It's worth doing a diff between the two.
seems OK, but mine is not good .... any ideas its from ipad 2 1395 & 1396 :
19:10:39.085 -> heap_feng_shui_req: setup status = 0, data status = 4 19:10:39.085 -> heap_feng_shui_req: setup status = 0, data status = 4 19:10:39.085 -> heap_feng_shui_req: setup status = 0, data status = 4 ..................................................................... 19:10:39.132 -> heap_feng_shui_req: setup status = 0, data status = 4 19:10:39.132 -> heap_feng_shui_req: setup status = 0, data status = 4 19:10:39.132 -> heap_feng_shui_req: setup status = 0, data status = 4 19:10:39.226 -> 2. set global state 19:10:39.226 -> OUT pre-packet: 0 19:10:39.226 -> Send random 0x40 bytes: 4 19:10:39.226 -> Send random 0x40 bytes HS: 5 19:10:39.226 -> Send zero length packet: 5 19:10:39.226 -> Send get status #1: 5 19:10:39.226 -> Send get status #2: 5 19:10:39.226 -> data: 4 19:10:39.226 -> sending error 19:10:39.272 -> 3. heap occupation 19:10:39.272 -> heap_feng_shui_req: setup status = 0, data status = 0 19:10:39.318 -> overwrite sending ... 19:10:39.318 -> SETUP: 0 19:10:39.318 -> OUT (pre packet): 4 19:10:39.318 -> OUT: 0 19:10:39.318 -> payload sending ... 19:10:39.318 -> SETUP: 0 19:10:39.318 -> OUT (pre packet): 0 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.318 -> OUT: 4 19:10:39.365 -> Done!
Have you tried the synackuk version?
Yes, but the difference in synackuk's repo is in the payload only and I'm having trouble at 'set global state' phase
Uhhh. . I have the same issue with my iPad3(3,1).I tried both a1ex's version and synackuk's version,but none of them work on my ipad.How did you end up solving the problem? If so, can you post the correct output, thanks
What's your output?
What's your output?
The same as yours
What's your output?
Any clues?
I get the following output in the serial monitor from Arduino, but can't get the bypass tool to work as it says the device is not in pwned mode:
_checkm8 started