Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.19
List the steps to reproduce the problem below (if possible attach a sketch or
copy the sketch code in too):
Select Feather RP2040
Load either of the miniTFTWing examples
Build and upload
Underlying issues:
Example is missing pin assignment code for RP2040 (e.g. Wire.setSDA...).
RP2040 Feathers use GPIO2/3 for I2C pins. These are valid hardware pins, but are assignable only to Wire1. The mini TFT wing lib (which lives in the SeeSaw lib) only uses Wire.
The plain Feather RP2040 uses GPIO7/8 for feather pins 5/6. It looks like subsequent boards use GPIO5/6 pins. Don't think this one is fixable in code, but a good comment would have been helpful.
Arduino board: Feather RP2040
Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.19
List the steps to reproduce the problem below (if possible attach a sketch or copy the sketch code in too):
Underlying issues:
Wire.setSDA...).Wire1. The mini TFT wing lib (which lives in the SeeSaw lib) only usesWire.