Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.9
List the steps to reproduce the problem below (if possible attach a sketch or
copy the sketch code in too):
Run Example SSD1305 with the line for the 128x32 pixel display uncommented.
Hello. Forwarding some issues other people have had with this library for the 128x32 display, it seems I can't get it working properly, even after updating to the 1.0.3 release of December which should fix most of these issues. I dropped a pic below to show what happens. It is connected via I2C, with a pullup on the reset pin.
Arduino board: Custom Board Based on Feather M0
Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.9
List the steps to reproduce the problem below (if possible attach a sketch or copy the sketch code in too):
Run Example SSD1305 with the line for the 128x32 pixel display uncommented.
Hello. Forwarding some issues other people have had with this library for the 128x32 display, it seems I can't get it working properly, even after updating to the 1.0.3 release of December which should fix most of these issues. I dropped a pic below to show what happens. It is connected via I2C, with a pullup on the reset pin.