/*****
This is an example for our Feather Bluefruit modules
Pick one up today in the adafruit shop!
Adafruit invests time and resources providing this open source code,
please support Adafruit and open-source hardware by purchasing
products from Adafruit!
MIT license, check LICENSE for more information
All text above, and the splash screen below must be included in
any redistribution
*****/
/*
This sketch demonstrate how to use Hardware Serial1 along with
native USB Serial on Bluefruit nRF52840.
Note: Bluefruit nRF52832 does not support Serial1
*/
include
include // for Serial
void setup()
{
// Open serial communications and wait for port to open:
Serial.begin(115200);
while ( !Serial ) delay(10); // for nrf52840 with native usb
Serial.println("Goodnight moon!");
// set the data rate for the SoftwareSerial port
//mySerial.begin(9600);
//mySerial.println("Hello, world?");
void loop() // run over and over//
{
if (Serial1.available())
Serial.write(Serial1.read());
if (Serial.available())
Serial1.write(Serial.read());
}
What happened ?
Anything written on Serial will print to Serial1. Anything written on Serial1 does nothing on Serial. The example sketch clearly does not work, even though it should, because this is a fundamental sketch.
Operating System
Windows 11
IDE version
1.8.19
Board
ItsyBitsy nRF52840 Express
BSP version
1.6.0
Sketch
/***** This is an example for our Feather Bluefruit modules
Pick one up today in the adafruit shop!
Adafruit invests time and resources providing this open source code, please support Adafruit and open-source hardware by purchasing products from Adafruit!
MIT license, check LICENSE for more information All text above, and the splash screen below must be included in any redistribution *****/
/*
include
include // for Serial
void setup() { // Open serial communications and wait for port to open: Serial.begin(115200); while ( !Serial ) delay(10); // for nrf52840 with native usb
Serial.println("Goodnight moon!");
// set the data rate for the SoftwareSerial port //mySerial.begin(9600); //mySerial.println("Hello, world?");
Serial1.begin(115200); Serial1.println("Hello, world?"); }
void loop() // run over and over// { if (Serial1.available()) Serial.write(Serial1.read());
if (Serial.available()) Serial1.write(Serial.read()); }
What happened ?
Anything written on Serial will print to Serial1. Anything written on Serial1 does nothing on Serial. The example sketch clearly does not work, even though it should, because this is a fundamental sketch.
How to reproduce ?
Run the Serial1_test example.
Debug Log
No response
Screenshots
No response