Thanks for sharing your button/switch data with the community.
Please note:
This issue is for a particular instance of a switch/button of the original poster. If someone else wants to test the same switch model, they should create a new issue.
The original poster can add additional test sessions to this issue (if they wish) by adding a comment.
Switch Info
Please fill out the following information about the switch you are testing:
How new is the switch? barely used. Received December 2019.
How do you like the switch:
It's a really nice looking button (especially with the LED), but isn't really enjoyable to press. The button face is small and flush with the housing which makes it a bit uncomfortable to press. Fine for occasional use. This makes it vandal resistant (hitting it with a hammer/stick would hit the housing and not really the button face).
Anything else noteworthy:
I soldered the wires in my garage in -20C weather. Lead free solder too. It wasn't my best work :)
Marketing images:
Test Session 1
Setup
Property
Description
Arduino model
Uno (SMD)
Pull-up resistor
Arduino internal (42.2k measured)
Switch wires connection
soldered
Measure switch's ON resistance
0.3 ohms
Anything else connected?
nothing
Test Setup Photos:
Please upload picture(s) of your test setup showing how the switch is connected to your Arduino. Please be wary of insecure wires/connections as they can cause many signal glitches.
Results
Test Section Details
Fast presses were done with the pen so that I could hit it quickly. slow presses were done with the pen too. The larger pen body lined it up nicely with the button face. I could slide the pen against the table very controlled/slowly.
Thanks for sharing your button/switch data with the community.
Please note:
Switch Info
Please fill out the following information about the switch you are testing:
Product URL: link
How new is the switch? barely used. Received December 2019.
How do you like the switch: It's a really nice looking button (especially with the LED), but isn't really enjoyable to press. The button face is small and flush with the housing which makes it a bit uncomfortable to press. Fine for occasional use. This makes it vandal resistant (hitting it with a hammer/stick would hit the housing and not really the button face).
Anything else noteworthy: I soldered the wires in my garage in -20C weather. Lead free solder too. It wasn't my best work :)
Marketing images:
Test Session 1
Setup
Test Setup Photos: Please upload picture(s) of your test setup showing how the switch is connected to your Arduino. Please be wary of insecure wires/connections as they can cause many signal glitches.
Results
Test Section Details
Fast presses were done with the pen so that I could hit it quickly. slow presses were done with the pen too. The larger pen body lined it up nicely with the button face. I could slide the pen against the table very controlled/slowly.
📄 Raw data
banggood 1196605 pushbutton red.txt
You can graph/analyze the data here.
🖼️ Summary Image
🕵️ Your Observations (optional)
The switch performed very well.