search

adonno / tagreader

Simple to build/use NFC tag reader, specially created for Home Assistant
https://adonno.com
GNU General Public License v3.0
1.18k stars 185 forks source link

Can´t read NFC tags #167

Closed nedflanders11 closed 1 year ago

nedflanders11 commented 2 years ago

Hello!

Thanks for this wonderful project.

I´ve have received my tagreader this week. It worked fine the first day (integrated in my Home Assistent, reading tags, automations, ...). It was perfect.

In the evening I have unplugged the USB-C. On the next day I have plugged in the USB-C again. After a few seconds the tagreader was in status "connected" (Home Assistant).

From now on the tagreader didn´t read tags anymore. It´s still possible to switch on/off the LED, restarting, ..., but reading tags is not possible.

In the esphome-flasher is no log after scanning. But there are log entries when I switch on/off the LED, ...

Any suggestions? Thanks!

adonno commented 2 years ago

Can you update your tagreader via[https://adonno.github.io/tagreader]() and let me know?

nedflanders11 commented 2 years ago

Thanks for your fast feedback.

Recommended update (ESPHome 2022.3.2) successfully done. Unfortunately still the same behavior. I have deleted the ESPHome integration in Home Assistant. Afterwards integrated again. Same behavior.

nedflanders11 commented 2 years ago

I´ve done a restart and have seen the following three errors:

I][logger:214]: Log initialized [C][ota:461]: There have been 0 suspected unsuccessful boot attempts. [I][app:029]: Running through setup()... [I][i2c.arduino:161]: Performing I2C bus recovery [E][i2c.arduino:177]: Recovery failed: SCL is held LOW on the I2C bus [D][template.switch:050]: Restored state ON [D][switch:013]: 'TagReader Buzzer Enabled' Turning ON. [D][switch:037]: 'TagReader Buzzer Enabled': Sending state ON [D][template.switch:050]: Restored state ON [D][switch:013]: 'TagReader LED enabled' Turning ON. [D][switch:037]: 'TagReader LED enabled': Sending state ON [C][esp8266_pwm:017]: Setting up ESP8266 PWM Output... [C][light:036]: Setting up light 'TagReader LED'... [D][light:035]: 'TagReader LED' Setting: [D][light:040]: Color mode: RGB [D][light:084]: Transition length: 1.0s [C][pn532:018]: Setting up PN532... [E][pn532:022]: Error sending version command [E][component:112]: Component pn532 was marked as failed.

adonno commented 2 years ago

Would you mind opening the device and sending me an image of the soldering spots please ?

nedflanders11 commented 2 years ago

Please see attachment: tagreader

adonno commented 2 years ago

I'll send you a new one i guess , Can you email me your initial order number adonno@adonno.com

nedflanders11 commented 2 years ago

Hi Andrea, I just sent you an e-mail with the order number. Thanks a lot!

adonno commented 2 years ago

Ok i will come back to it by end of week

adonno commented 1 year ago

sent a new device