I see a column for "CO2 Calibration Requested" with a checkbox, but you cannot check the box here to request calibration. I think this is confusing as an end user, so if this is not supposed to be clickable, I think changing it to a Yes/No or True/False string would be better to understand.
I did find after poking around that if I click the three dot menu to the far right of a Monitor, I could select "Edit Location" and see another "Request CO2 calibration", which I checked and clicked Save. In the Hardware page, I briefly saw it checked, but clicking the blue Refresh button cleared the checkbox. After the first time I did this nothing updated on my sensor that I could tell, even though the checkbox had cleared. I still had incorrect numbers for CO2.
I tried it again about 5 minutes later, and maybe it did eventually work from the first attempt, but after requesting calibration a second time and going back to see the current values, it was updated.
Summary:
Checkbox in the hardware page is misleading since users can't check it and must Edit Location to request it
In the Hardware page, a Yes/No value for "CO2 Calibration Requested" would be more clear
In Edit Location, I think the c in calibration should be capitalized to match the Hardware page where it is capitalized. Consistency is key
If possible, once calibration is requested, the checkbox/true on the Hardware page should stay until the calibration is completed, rather than resetting immediately
I don't think "Edit Location" is an intuitive place to find the option to request CO2 calibration. Perhaps its own menu under the 3 dots in the Admin column, so it had "Edit Location", "Show Monitor Information", and "Request CO2 Calibration"
I'm not sure if this is most appropriate here or in the Forums, since it seems to be more related to the Dashboard page.
Going to the Hardware page I can see all of my devices and when they were last seen: https://app.airgradient.com/settings/hardware
I see a column for "CO2 Calibration Requested" with a checkbox, but you cannot check the box here to request calibration. I think this is confusing as an end user, so if this is not supposed to be clickable, I think changing it to a Yes/No or True/False string would be better to understand.
I did find after poking around that if I click the three dot menu to the far right of a Monitor, I could select "Edit Location" and see another "Request CO2 calibration", which I checked and clicked Save. In the Hardware page, I briefly saw it checked, but clicking the blue Refresh button cleared the checkbox. After the first time I did this nothing updated on my sensor that I could tell, even though the checkbox had cleared. I still had incorrect numbers for CO2.
I tried it again about 5 minutes later, and maybe it did eventually work from the first attempt, but after requesting calibration a second time and going back to see the current values, it was updated.
Summary: